North Light Tilting Copy Stand

Quickly change from a vertical copy stand to a horizontal copy stand by simply tilting the stand over and setting the support frame on the floor. This Multi-Purpose stand can be used to copy artworks on the baseboard or easily remove the baseboard and place a table, or an un-used desk over the base legs and work at more comfortable height. When changing to a table or desk simply Zig-align to the new surface using the Heavy Duty Gear Head included with the copy stand.

When artworks, maps, etcetera, are large and would be difficult to focus or control the camera from a high position on a ladder, leaning over the art,  just tip the stand over and work standing on the floor at a more comfortable position. An artwork of 40x30 inches is easily imaged on the baseboard with a 4x5 camera and 135 mm lens.

Our Tilting Copy Stand comes with a wooden baseboard covered with metal so it is ready to use as a magnetic copy board.

The Tilting Copy Stand is a manual wind up and down system.

It comes with Base, Baseboard, Tilting support frame, Heavy Duty Gear Head.

$4950.00

Measurments:


Base is 44 inches wide and 33 inches deep.

Column is 96 inches long.

Over all height is 112 inches.
 

North Light Tilting Copy Stands are built to order. Please call today for more information.

Here is another photo of the copy stand with our 900 watt lights. The copy lights are shown with two sets of 900 watt lights which would not be normal for this setup but it does show that you can mount two lights on our North Light Copy Light Stands for those customers that are shooting large works on the wall.

Please note that the copy stand base will be at an angle when tipped down and if cross-polarization is used you must tilt down the copy lights and also rotate them to the compound angle to get 100% total cross-polarized light. This is accomplished by using our Swivel adapter.

Note that when using the Tilting Copy stand in the horizontal slanted position that you will need to use our copy light stands because even a LowBoy Jr. Stand will not get the light low enough to the floor.

A 40x30 vacuum table is still in design for this system.
Lights and stands are found on the
Copy Light page.

Optional Zig-align ZP4 system is $484.00